HIKVISION DS-2XS6A87G1-LS/4G - Wiegand; Power Consumption Mode

Figure 9-2 Manual Sengs
Note
This funcon may vary according to dierent device models.
9.18 Wiegand
Note
This funcon is only supported by certain camera models.
Check Enable and select the protocol. The default protocol is SHA-1 26bit.
If enabled, the recognized license plate number will be output via the selected Wiegand protocol.
9.19 Power
Consumpon Mode
It is used to switch the power consumpon when the device is working.
Note
The funcon is only supported by certain camera models.
Go to Conguraon → Proacve Mode → Power Consumpon Mode , select the desired power
consumpon mode.
Performance Mode
The device works with all the
funcons enabled.
Standby Mode
The device only support certain funcons and does not support seng the funcons.
Note
Some devices only support remote access wake-up and guarding schedule funcons in this
mode.
Proacve Mode
Network Camera User Manual
80