DS-Eco Series Workstation (Windows) User Manual
12
Chapter 3 HDD Installation
Purpose
The following section introduces the HDD installation.
Before you start
Disconnect the power from the device before installing a hard disk drive (HDD). A factory
recommended HDD should be used for this installation.
Tools Required: Screwdriver.
Step 1 Remove the cover from device by unfastening the screws on panels.
Figure 3-1 Remove Cover
Step 2 Connect the data cable and power cable.
1) Connect one end of data cable to the device motherboard.
2) Connect the other end of data cable to HDD.
3) Connect one end of power cable to HDD.
4) Connect the other end of power cable to the device motherboard.
Figure 3-2 Connect Cables
Step 3 Set the device up, match HDD screw threads with the reserved holes on the device bottom,
and fix HDD with screws.
To Next Page
Loading...