Video Access Control Terminal User Manual
31
Checking Device Information
Steps:
1. In the device list, you can click Remote Configuration to enter the remote configuration interface.
2. Click System -> Device Information to check the device basic information and the device version
information.
Editing Device Name
In the Remote Configuration interface, click System -> General to configure the device name and overwrite
record files parameter. Click Save to save the settings.
Editing Time
Steps:
1. In the Remote Configuration interface, click System -> Time to configure the time zone.
2. (Optional) Check Enable NTP and configure the NTP server address, the NTP port, and the synchronization
interval.
3. (Optional) Check Enable DST and configure the DST star time, end time and the bias.
To Next Page
Loading...
