Video Access Control Terminal User Manual
32
4. Click Save to save the settings.
System Maintenance Settings
Steps:
1. In the Remote Configuration interface, click System -> System Maintenance.
2. Click Reboot to reboot the device.
Or click Restore Default Settings to restore the device settings to the default ones, excluding the IP address.
Or click Restore All to restore the device parameters to the default ones. The device should be activated
after restoring.
Or click Import Configuration File to import the configuration file from the local PC to the device.
Or click Export Configuration File to export the configuration file form the device to the local PC.
The configuration file contains the device parameters.
3. In the Remote Upgrade part, select a upgrade file type in the dropdown list. Click to select the upgrade
file. Click Upgrade to start upgrading.
You are able to select Controller Upgrade File, Card Reader Upgrade File and Distributed Controller Upgrade
File in the drop-down list.
To Next Page
Loading...
