HIKVISION DS-K1T981MF User Manual

Steps
Note
The
funcon should be supported by the device.
1. T
ap Comm. (Communicaon Sengs) on the Home page to enter the Communicaon Sengs
page.
2. On the Communicaon Sengs page, tap.
Figure 7-5 Wi-Fi
Sengs
3. Enable the Wi-Fi funcon.
4. Congure the Wi-Fi parameters.
-
Select a Wi-Fi from the list, and enter the Wi-Fi's password. Tap OK.
-
If the target Wi-Fi is not in the list,tap Add Wi-Fi. Enter the Wi-Fi's name and password. And
tap OK.
Note
Only digits, leers,
and special characters are allowed in the password.
5. Se
t the Wi-Fi's parameters.
-
By default, DHCP is enable. The system will allocate the IP address, the subnet mask, and the
gateway automacally.
DS-K1T981 Series Access Control Terminal User Manual
41

HIKVISION DS-K1T981MF Specifications

General

Brand	HIKVISION
Model	DS-K1T981MF
Category	Touch terminals
Language	English