HIKVISION DS-K3B530X Series - Study Mode Settings

Note
-
The conguraon No. will display in a cycle.
-
Each conguraon No. refers to a funcon. For details about the conguraon No. and its
related funcon, see Buon Conguraon Descripon .
4.4.2 Study Mode Sengs
Set the closed posion of the device barrier.
Set Study Mode via Buon
Enter the study mode through buon conguraon to set the closed posion of the device barrier.
Steps
Note
●
If the device is equipped with access control board, you can set study mode via DIP switch on
the access control board only.
●
For details about buon's operaon, see Conguraon via Buon .
●
For details about the
conguraon No. and its related funcon, see Buon Conguraon
Descripon .
1.
Enter the study mode.
1) Enter the
conguraon mode.
2) Set the conguraon No. in Level-1 to 1. The device will enter the study mode.
3) Set the
conguraon No. in the Level-2 menu to 2. The device will enter the study mode.
2.
Power o the device and swing the barrier unl it is vercal to the pedestal.
3.
Power on the device.
The device will remember the current
posion automacally.
4.
Reboot the device when you hear Study accomplished. Please reboot.
Set Study Mode via DIP Switch
(Oponal)
Enter the study mode through DIP switching to set the closed posion of the device barrier.
Steps
1.
Set the No.1 of the 2-digit DIP switch on the access control board to ON by referring the
following
gure to enter the study mode.
DS-K3B530X Series Swing Barrier User Manual
33