HIKVISION DS-K3B530X Series - Page 48

3.
Exit the keyfob pairing mode.
1) Enter the conguraon mode.
2) Set the conguraon No. in Level-1 to 2. The device will enter the keyfob pairing mode.
3) Set the
conguraon No. in the Level-2 menu to 1. The device will exit the keyfob pairing
mode.
4.
Reboot the device to take eect.
Pair Keyfob via DIP Switch (Oponal)
Pair the remote control to the device through DIP switch to open/close the barrier remotely.
Before You Start
Ask our technique supports or sales and purchase the keyfob.
Steps
1.
Power
o the turnsle.
2.
Set the No.2 switch of the DIP Switch on the access control board to the ON side.
Figure 4-24 DIP Switch Locaon
DS-K3B530X Series Swing Barrier User Manual
36