HIKVISION DS-K3B530X Series - Initialize Device

Figure 4-25 Enable Keyfob Paring Mode
3.
Power on the turnsle and it will enter the keyfob pairing mode.
4.
Hold the Close
buon for more than 10 seconds.
The keyfob's indicator of the will ash twice if the pairing is completed.
5.
Set the No.2 switch to the OFF side, and reboot the turnsle to take eect.
Note
●
Only one turnsle can pair the keyfob. If mulple turnsles are in the pairing mode, the
keyfob will select only one of them to pair.
●
For details about DIP switch value and meaning, see DIP Switch Descripon .
6.
Oponal: Go to System → User → Keyfob User on the remote control page of the client
soware to delete the keyfob.
4.4.4
Inialize Device
Steps
1.
Hold the
inializaon buon on the access control board for 5 s.
Figure 4-26 Inializaon Buon Posion
2.
The device will start restoring to factory sengs.
3.
When the process is nished, the device will beep for 3 s.
Cauon
The inializaon of the device will restore all the parameters to the default seng and all the
device events are deleted.
Note
Make sure no persons are in the lane when powering on the device.
DS-K3B530X Series Swing Barrier User Manual
37