HIKVISION DS-K3G411 Series - Page 25

Interface Name Terminal Name Descripon Remark
GND Grounding
K2 Door 2 Signal Input
Fire Input XF Fire System Input /
GND Grounding
Event Input CASE1 Event Alarm Input 1
Note
The alarm input
hardware interface is
normally open by
default. So only the
normally open signal
is allowed. It can be
linked to the buzzer of
the card reader and
access controller, and
the alarm relay output
and open door relay
output.
GND Grounding
CASE2 Event Alarm Input 2
Network Interface LAN Network Accessing /
Side Light Board / Light Board Accessing /
Arm Posion Control
Board
/ Arm Posion Control
Board Accessing
/
Debugging Port / For Debugging Only /
Sucon Type
Electromagnet
/ Sucon Type
Electromagnet
Accessing
/
Push Pull Type
Electromagnet
/ Push Pull Type
Electromagnet
Accessing
/
BUS / BUS Accessing
Note
For details, see the
BUS terminal
descripon table
below.
DS-K3G411 Series Tripod Turnsle Quick Start Guide
14