HIKVISION DS-K3Y501SX Series

To Next Page

To Previous Page

Figure 3-3 Entrance Mark on Pedestal

Note

Make sure the installaon holes on the pedestals and the base are aligned with each other.

5. Secure the pedestals with expansion bolts.

Note

• Do not immerse the pedestal in the water. In special circumstances, the immersed height

should be no more than 150 mm.

• The installaon footprint is as follows:

Figure 3-4 Installaon Footprint

6. Remove the auxiliary scks at the boom of the device aer the device is fully installed. And

then use the concrete to seal the holes.

DS-K3Y501SX Series Flap Barrier Quick Start Guide

HIKVISION DS-K3Y501SX Series - Page 19