HIKVISION DS-K3Y501SX Series - Chapter 4 General Wiring; Components Introduction

To Next Page

To Previous Page

Chapter 4 General Wiring

4.1 Components Introducon

By default, basic components of the turnsle are connected well. The pedestals can communicate

by wiring the interconnecng cables. And the turnsle supports wiring the AC electric supply for

the whole system's power supply.

Note

The voltage uctuaon of the electric supply is between 100 VAC and 220 VAC, 50 to 60 Hz.

The picture displayed below describes each component's posion on the turnsle.

Note

The diagram is for reference only.

Figure 4-1 Components Diagram 1

Note

For details about wiring arrangement, refers to the actual device.

The picture displayed below describes the IR adapter and the IR sending/receiving module and

their corresponding number on the pedestal.

DS-K3Y501SX Series Flap Barrier Quick Start Guide