HIKVISION DS-K3Y501SX Series - Initialize Device

To Next Page

To Previous Page

3. Power on the

turnsle and it will enter the keyfob pairing mode.

4. Hold the Close

buon for more than 10 seconds. Or pair turnsle and keyfob in the client

soware, see Manage Keyfob User of the user manual for more details.

The keyfob's indicator of the will

ash twice if the pairing is completed.

5. Set the No.4 switch to OFF, and reboot the

turnsle to take eect.

Note

• Only one

turnsle can pair the keyfob. If mulple turnsles are in the pairing mode, the

keyfob will select only one of them to pair.

• For details about DIP switch value and meaning, see DIP Switch .

Oponal: Go to System → User → Keyfob User on the remote control page of the client

soware to delete the keyfob.

5.2

Inialize Device

Steps

1. Remove the JP11 jumper cap on the access control board.

Figure 5-1 Inializaon Jumper Cap

2. Disconnect the power and reboot the device. The device buzzer buzzes a long beep.

3. When the beep stopped, plug the jumper cap back.

4. Disconnect the power and power on the device again.

DS-K3Y501SX Series Flap Barrier Quick Start Guide