EasyManua.ls Logo

HIKVISION DS-MDS003 - Page 4

HIKVISION DS-MDS003
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DS-MDS003 Dock Station (For DS-MCW405/32G/GPS/WIFI Body Cameras) Quick Start Guide
QSG DS-MDS003 0415221NA 4
Store the device in dry, well-ventilated, corrosive-gas-free, no direct sunlight, and no heating
source environment.
Avoid fire, water, and explosive environment when using the device.
Avoid lightning strike for device installation. Install a lightning arrester if necessary.
Keep the device away from magnetic interference.
Avoid device installation on vibratory surfaces or places, and avoid equipment installation on
vibratory surfaces or places subject to shock (ignorance may cause device damage).
DO NOT touch the heat dissipation component to avoid burns.
DO NOT expose the device to extremely hot, cold, or humidity environments. For temperature and
humidity requirements, see device specification.
The device can be safely used in only regions below 2000 meters above sea level.
Maintenance
If smoke, odor, or noise arises from the device, immediately turn off the power, unplug the power
cable, and contact the service center.
If the device behaves abnormally, contact the store you purchased it from or the nearest service
center. DO NOT disassemble or modify the device in any way (For the problems caused by
unauthorized modification or maintenance, the company shall not take any responsibility).
Keep all packaging after unpacking for future use. In case any failure occurs, you need to return
the device to the factory in the original packaging. Transportation without the original packaging
may result in damage to the device, and the company shall not take any responsibility.
Network
Enforce protection for personal information and the data security as the device may confront
network security problems when it is connected to the Internet. Please contact us if the device
might confront network security risks.
Understand that you have the responsibility to configure all the passwords and other device
security settings and keeping your user name and password confidential.
Lens
DO NOT touch the lens with fingers directly in case the acidic sweat of the fingers erodes the
surface coating of the lens.
DO NOT aim the lens at a strong light such as the sun or an incandescent lamp. The strong light can
cause fatal damage to the device.
Screen
Clean the screen with a soft and dry cloth or other substitute to wipe the interior and exterior surface. DO
NOT use alkaline detergents. Protect the screen from scratches.

Other manuals for HIKVISION DS-MDS003