Panic Alarm Master Station • User Manual
12
Password: The user name which the device registers to the SIP server.
Device ID.: The ID number of the device, the available number should be between 0 and 999999.
Note: Device ID is the unique identification of the device, facilitating the communication between the master
station and the alarm device.
Device Location: The location information of the device, the location information ranges in length from 1 to 32
characters.
Register Period (min): The interval that the device continuously registers to the SIP server, the register period
ranges from 1 to 30 (min).
Note: When switching between private protocol and SIP protocol, the device must be restarted to take effect.
Tap Save.
Device Management
Purpose:
In this section, you can set up groups for alarm devices and configure them, configure the parameters of master
stations, and add network camera.
Configuring Alarm Device
Purpose:
In this section, you are able to configure the general information of alarm devices, set up groups for alarm
devices, manage groups and alarm devices, set call forwarding and hubbub alarm parameters for alarm devices.
Note: Before configuring the alarm device, you need configure the SIP server for the master station, and ensure
that alarm devices and the master station register to the same SIP server.
Steps:
On the home page of master station, tap System Config to enter the page.
Tap to enter the Device page.
Tap Group to enter the Group page, you are able to create groups and manage them, favorite and manage
the alarm device.
To Next Page
Loading...
