Panic Alarm Master Station • User Manual
21
Setting Sounds Parameters of Master Station
Purpose:
In this section, you are able to set the call ringtone, ring duration, audio input/output and its corresponding
volume and keypad sound.
Steps:
On the home page of master station, click System Config to enter the page.
Tap to enter the General page.
Tap Sounds to enter the sound configuration page.
Sounds Configuration Page
Call Ringtone: Tap Call Ringtone to select an audio file in the pop-up window. You are able to select the
audio file from local file list or SD card file list as the call ringtone. The default call ringtone is call_ringtone1.
Note: The local audio file comes with the device. The SD card audio file requires to be uploaded, and you
need to insert the SD card into the microSD card interface for using the SD card audio file.
Ring Duration (s): Enter the ring duration for the incoming call. By default, it is 30, the available value is 30 to
60.
Note: The ring duration is only applied to the master station call master station, and the called master station
determines the ring duration.
Audio Input: Tap Audio Input to select an audio input in the pop-up window. You are able to select Mic In
(comes with the device), Line In1 (3.5 mm input) and Line In2 (the mic support) as the audio input to be
configured.
Mic In Volume/Line In1 Volume/Line In2 Volume: Set the volume of the selected audio input.
Audio Output: Tap Audio Output to select an audio output in the pop-up window. You are able to select Spk
Out (comes with the device), Line Out (3.5 mm output) and Spk Out & Line Out as the audio output to be
configured.
Speak Out Volume: Set the volume of Speaker output.
To Next Page
Loading...
