HIKVISION DS-PR1-WE - Page 3

2.Install the device.
a. Route the cable through the boom cable hole or knock-out cable hole.
b. Mount the device.
4
Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
3
a b
KA3×25
Set up with App
Funcon
Polling Rate
Pairing
Signal Strength Test
Find Me
Tap Signal Strength Test to start test.
Set the interval of heartbeat.
Descripon
1. On the device list page, tap the AX PRO and then log in to the device (if required).
2. Tap Device, and tap the Repeater.
You can view the device status including baery status, mains power supply, signal strength, connecon status, connected
device number and lid status.
3. Tap the buon in the upper right corner to enter the sengs page.
Tap Pairing to enable the repeater to serve as a
transfer staon for pairing between the peripheral
and the control panel.
Device Name Tap to edit the device name.
Tap Find Me to make peripherals find the reapeater.