DS-Pro Series Workstation User Manual
20
Chapter 4 HDD Installation
Purpose
The following section introduces the HDD installation. 2.5-inch HDD and 3.5-inch HDD are
supported.
Before you start
Disconnect the power from the device before installing a hard disk drive (HDD). A factory
recommended HDD should be used for this installation.
Tools Required: Screwdriver.
Step 1 For 3.5-inch HDD, fix mounting ears to HDD with screws.
Figure 4-1 Fix Mounting Ears to 3.5-inch HDD
For 2.5-inch HDD, fix HDD adaptor to HDD with screws
Figure 4-2 Fix HDD Adaptor to 2.5-inch HDD
Step 2 Unlock the front panel with the attached key, and press the buttons on both sides of the
front panel to open it.
To Next Page
Loading...
