EasyManua.ls Logo

HIKVISION DS-TCG406-E - Page 15

HIKVISION DS-TCG406-E
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Fake Plate Filter
Aer you enable this funcon, if it is idened as a fake license plate, the device will not
output the captured picture and license plate informaon, and the barrier gate will not be
opened.
4.
Set Barrier Gate Control parameters.
Control Mode
Select By Camera in single camera scene (no control soware) and allowlist scene in which
the camera controls the barrier gate in advance according to the set passing rules in
Vehicle Informaon Management.
Select By
Plaorm in the scene in which the entry permissions are controlled by the
soware.
Select By Mixed, and the plaorm control and camera control are eecve simultaneously.
It is applicable to the scene in which dierent vehicle passing permissions are managed by
soware and camera. E.g., the soware controls the passing of blocklist vehicles and
temporary vehicles, and the camera controls the passing of allowlist vehicles and controls
the barrier gate in advance for allowlist vehicles.
Keep Barrier Open for Following Vehicle
Aer you enable this funcon, the barrier gate keeps open when the device detects following
vehicles are passing. The barrier gate will close
aer the following vehicles pass.
5.
Select Relay Funcon as needed.
Note
The supported number of relays varies with dierent models. Relay 1 corresponds to the 1A and
1B of the terminal. Relay 2 corresponds to the 2A and 2B of the terminal.
6.
Select IO Funcon for the corresponding barrier gate related I/O. The device will upload barrier
gate status informaon for convenient exit and entrance management.
Note
If the device only have one I/O interface, and the trigger type is I/O Coil, the barrier status
cannot be congured.
If the trigger type is Radar Mixed Trac and the forward radar and backward radar are
selected, the corresponding barrier gate related I/O
funcon cannot be congured. E.g., the
forward radar is IO1 and the backward radar is IO2. Then the barrier gate related IO1 and IO2
funcons cannot be congured.
7.
Oponal: Select the barrier gate operaons for temporary vehicles, vehicles of blocklist, and
vehicles of allowlist in Vehicle
Informaon Management.
What to do next
Click Next to set image adjustment parameters.
Intelligent Entrance ANPR Camera User Manual
7

Table of Contents

Other manuals for HIKVISION DS-TCG406-E

Related product manuals