HIKVISION DS-TCG406-E - 3.2.2 Set Capture Parameters

Capture is triggered according to the level signal status. If you select Falling Edge, the device
will trigger capture at the moment that the high level falls to low level. If you select Rising
Edge, the device will trigger capture at the moment that the low level rises to high level.
Linked I/O No.
The I/O No. linked under I/O coil mode. When the coil detects that there is a vehicle passing,
a rising or falling edge signal is sent to the linked I/O of the device to trigger capture.
Forward/Backward Radar
Radar Mixed
Trac shall be used with one forward radar and one backward radar. Select the
corresponding I/O No.
5.
Click Draw Lane Line to draw the lines.
1) Select the lane line, right border line, or trigger line.
2) Drag the endpoints to adjust the
posion and length of the line, or drag the line to adjust its
posion.
3) Click OK to save the sengs.
Note
It is recommended to draw the trigger line at the posion which is 1/3 to 1/4 of the lane line.
The license plate number height pixel should be between 25 to 35 pixels at the capture posion.
6.
Click Save.
3.2.2 Set Capture Parameters
Set License Plate Recognion Parameters
When there are vehicles of dierent types passing from dierent direcons, set the license plate
recognion parameters.
Steps
Note
The supported parameters vary with dierent models. The actual device prevails.
1.
Go to Conguraon → Capture → Capture Parameters → License Parameters .
Intelligent Entrance ANPR Camera User Manual
13