HIKVISION DS-TCG406-E - Page 61

Before You Start
●
Connect the device to the Internet.
●
Set the IP address, subnet mask, gateway, and DNS server of the LAN.
●
OTAP
connecon is disabled.
Steps
Note
This funcon varies with dierent models. The actual device prevails.
1.
Go to Conguraon → Network → Data Connecon → Hik-Connect Plaorm .
2.
Check Enable Hik-Connect
Plaorm.
Figure 9-4 Connect to Hik-Connect
3.
Select Protocol Version.
4.
Oponal: If you have allocated a custom server, check Custom and enter the custom Server
Domain Name.
5.
Add the device to Hik-Connect.
Set a
vericaon
code to add the
device to Hik-
Connect
a. Enter a custom Vericaon Code used to add the device.
Cauon
The vericaon code should be 6 leers or numbers, case sensive.
You are recommended to use a combinaon of leers or numbers.
b. Click Save.
c. Get and install Hik-Connect applicaon by the following ways.
Intelligent Entrance ANPR Camera User Manual
53