Parking Camera User Manual
31
Chapter 9 Network Configuration
9.1 Set IP Address
IP address must be properly configured before you operate the device over network. IPv4 and IPv6
are both supported. Both versions can be configured simultaneously without conflicting to each
other.
Go to Configuration → Device Configuration → System Configuration → TCP/IP for parameter
settings.
Figure 9-1 Set IP Address
NIC Type
Select a NIC (Network Interface Card) type according to your network condition.
IPv4
Two IPv4 modes are available.
Auto-Obtain
The device automatically gets the IPv4 parameters from the network if you check
Auto-Obtain. The device IP address is changed after enabling the function. You can use SADP
to get the device IP address.
Note
The network that the device is connected to should support auto-obtain.
To Next Page
Loading...