Parking Camera User Manual
33
Steps
1. Go to Configuration → Device Configuration → System Configuration → EHOME.
Figure 9-2 Connect to EHome Platform
2. Check Enable Protocol.
3. Select Address Type.
Domain Name
When the server is in extranet, and the IP address is dynamic, you can select it.
IP
When the server IP address is static, you can select it.
4. Enter the parameters below.
Server IP
Enter the static IP address of EHome platform.
Server Port
The default value is 7660.
Device ID
The ID of the device registered on the EHome platform. If you leave it empty, the device will
be logged in to the platform with serial No.
5. Click Save.
9.3 Set DDNS
You can use the Dynamic DNS (DDNS) for network access. The dynamic IP address of the device
can be mapped to a domain name resolution server to realize the network access via domain
name.
Before You Start
● Register the domain name on the DDNS server.
● Set the LAN IP address, subnet mask, gateway, and DNS server parameters. Refer to "Set IP
Address" for details.
● Complete port mapping. The default port is 80, 8000, and 554.
To Next Page
Loading...