Parking Camera User Manual
38
Steps
1. Go to Configuration → Device Configuration → System Configuration → Serial Port
Parameters.
2. Click Advanced Settings.
Figure 10-2 Set RS-232
3. Set Baud Rate, Data Bit, Stop Bit, etc.
Note
The parameters should be same with those of the connected device.
4. Select Working Mode.
Console
Select it when you need to debug the device via RS-232 serial port.
Transparent Channel
Select it, and the network command can be transmitted to RS-232 control command via the
RS-232 serial port.
Narrowband
Reserved.
5. Click Save.
To Next Page
Loading...