Barrier Gate User Manual
10
Chapter 2 Installation
2.1 Installation Environment
The installation position of the barrier gate should meet the customer’s requirements and the
following requirements.
● The installation space should be large enough to guarantee the boom pole can rise or fall
normally.
● Install the barrier gate on horizontal ground.
● Installation surface requirements:
○ If no base is installed, the installation surface must be firm enough to fix the host to
guarantee the barrier gate can run stably.
○ If base is needed, it is recommended to install the base with quick setting cement. The base
should be horizontal. The height should be no more than 300 mm. The length and width of
base should be larger than those of the actual barrier gate installation surface.
● If the barrier gate is anti-collision, the boom pole will flick 90° in reverse direction if it is
impacted. Make sure there is no obstacle in the range.
● Bury the cables before installation. The conduit should be 50 mm higher than the ground to
avoid the gathered water on the ground to enter into the cable and cause short circuit.
2.2 Install Barrier Gate Host
Follow the steps below to fix the host of barrier gate.
Steps
1. Mark the positions of holes on the refuge island as shown below. The hole depth is approx.
120 mm.
Figure 2-1 Mark Position
To Next Page
Loading...