Barrier Gate User Manual
11
Note
The suggestions for positions of holes:
● The holes in vertical direction should be near to the switch.
● If the entrance/exit is unidirectional, the holes should be in the horizontal center of the
refuge island. If the entrance/exit is bi-directional, the holes in the horizontal direction should
be far away from the entrance/exit.
2. Punch the four M12 × 150 expansion screws in the package into the marked positions on the
refuge island, and fasten the nuts to make the screws expand to grip the ground. Then
unfasten the nuts.
Figure 2-2 Install Expansion Screws
3. Uninstall the top and front covers.
1) Use the L-type key to unlock the top cover.
2) Lift the top cover gently and push it to take it down.
3) Lift the front cover gently to take it down.
Figure 2-3 Uninstall Top and Front Covers
4. Fix the host.
1) Put the layers on the host bottom and keep them perpendicular to the barrier gate’s switch.
To Next Page
Loading...