Barrier Gate User Manual
30
both ends.
Figure 2-38 Connect Boom Pole to Host via Pull Rod
2.4 Wiring
2.4.1 Connect to Power Supply
Connect the laid power cord (RVV3 × 1.5 mm
2
or above) to the power input of barrier gate. Install
the top and front covers. Use the L-type key to lock the top cover.
Danger
● Cut off the power before wiring.
● The power voltage of barrier gate is 220 VAC ± 10%. If the voltage exceeds the range, voltage
stabilizer is needed.
● Make sure the barrier gate is connected to the ground firmly, or it may cause electric shock.
To Next Page
Loading...