Barrier Gate User Manual
43
Chapter 3 Parameters Configuration
After the installation completes, power on the barrier gate, and it will operate self-check of rising
to limit position. After the self-check completes, you can control the barrier gate via remote
controller or buttons.
3.1 Remote Control
After the self-check completes, you can control the boom pole to rise, fall, and stop via the remote
controller leaving factory with the barrier gate.
3.2 Set Parameters via Control Board Buttons
3.2.1 Button Description
Rise the top cover of the host, and you can see the buttons and nixie tube. You can control the
barrier gate via the buttons and judge the status via the nixie tube.
There is respective initial status for the rising limit position, falling limit position, and rising speed
of the barrier gate. You can adjust them via buttons if the initial status cannot meet the
requirements of the installation site.
Figure 3-1 Control Buttons
Note
● If you need to hold the buttons to trigger operations, hold for 3 seconds or above.
● The nixie tube shows the status (e.g., H0) and fault codes (hexadecimal characters, e.g., 1A). If
the fault codes appear on the nixie tube, it means there is operation error. Contact the technical
personnel of our company to solve the problems.
To Next Page
Loading...