Falling Limit
Position
H1
CL
Hold the Learn button on the control board.
H0
Press the Learn button on the control board to save the settings.
Press the Fall button on the remote
controller or press the Fall button on the
control board to adjust the boom pole to
the falling limit position.
Hold the Rise/Fall button on the control
board to adjust the boom pole to the falling
limit position.
Figure 3-4 Adjust Falling Limit Position of Boom Pole
Adjust Rising Speed of Boom Pole
Steps
1. Press the Rise button on the remote controller, press the Rise button on the control board, or
power on the device to adjust the boom pole to the rising limit position.
2. Hold the Learn button on the control board until “H0” appears on the nixie tube.
3. Press the Rise/Fall button on the control board to increase/decrease the value on the nixie
tube. Adjust the value to “H2”.
4. Hold the Learn button on the control board to enter the menu settings.
5. Press the Rise/Fall button on the control board to adjust the value on the nixie tube.
Note
The L3 rising speed is faster than L2, which is faster than L1. Adjust the speed according to your
needs.
6. Press the Learn button on the control board to save the settings. “H2” will appear on the nixie
tube.
To Next Page
Loading...