HIKVISION DS-TMG520-H/A/B - Page 54

Barrier Gate User Manual
48
Rising Limit
Position
Press the Rise/Fall button
on the control board to
increase/decrease the value
on the nixie tube.
H2
L3
Hold the Learn button on the control board to enter the menu settings.
H2
Press the Learn button on the control board to save the settings.
H0
Hold the Learn button on the control board.
Press the Rise/Fall button on the control
board to adjust the value on the nixie
tube.
The rising speed: L3 > L2 > L1
Press the Rise button on the remote
controller, press the Rise button on the
control board, or power on the device to
adjust the boom pole to the rising limit
position.
Figure 3-5 Adjust Rising Speed of Boom Pole
Adjust Falling Speed of Boom Pole
Steps
1. Press the Rise button on the remote controller, press the Rise button on the control board, or
power on the device to adjust the boom pole to the rising limit position.
2. Hold the Learn button on the control board until “H0” appears on the nixie tube.
3. Press the Rise/Fall button on the control board to increase/decrease the value on the nixie
tube. Adjust the value to “H3”.
4. Hold the Learn button on the control board to enter the menu settings.
5. Press the Rise/Fall button on the control board to adjust the value on the nixie tube.
Note
The L3 falling speed is faster than L2, which is faster than L1. Adjust the speed according to your
needs.
6. Press the Learn button on the control board to save the settings. “H3” will appear on the nixie
tube.