Rising Limit
Position
Press the Rise/Fall button
on the control board to
increase/decrease the value
on the nixie tube.
H8
1
Hold the Learn button on the control board to enter the menu settings.
H8
Press the Learn button on the control board to save the settings.
H0
Hold the Learn button on the control board.
Press the Rise/Fall button on the control
board to adjust the value on the nixie
tube.
1: Enable locking barrier gate via the
remote controller.
0: Disable locking barrier gate via the
remote controller.
Press the Rise button on the remote
controller, press the Rise button on the
control board, or power on the device to
adjust the boom pole to the rising limit
position.
Figure 3-11 Enable Locking Barrier Gate via Remote Controller
Lock Barrier Gate
Lock the barrier gate via the remote controller. Press the Rise, Stop, and Rise buttons on the
remote controller in sequence until “Lc” appears on the nixie tube.
Set Rising Limit Output Mode
Steps
1. Press the Rise button on the remote controller, press the Rise button on the control board, or
power on the device to adjust the boom pole to the rising limit position.
2. Hold the Learn button on the control board until “H0” appears on the nixie tube.
3. Press the Rise/Fall button on the control board to increase/decrease the value on the nixie
tube. Adjust the value to “H9”.
4. Hold the Learn button on the control board to enter the menu settings.
5. Press the Rise/Fall button on the control board to adjust the value on the nixie tube.
Note
Adjust the value to 1 to enable outputting the rising pulse after the boom pole rises to the rising
limit position, and 0 to disable the function.
6. Press the Learn button on the control board to save the settings. “H9” will appear on the nixie
tube.
To Next Page
Loading...