Barrier Gate User Manual
66
Figure 4-13 Remove Motor Wire
2. Remove the M8 hex socket head cap screws of the machine core with a No. 6 hex wrench.
3. Disassemble the machine core and change a new one.
4. Fix the machine core with the M8 hex socket head cap screws, put motor wire into the wire
slot, connect the power cord and signal line terminals, and then fix the grounding terminal.
Figure 4-14 Fix Machine Core
5. Install the boom pole. Refer to 4.2 Change Boom Pole for details.
6. Install the spindle rod. Refer to 4.3.2 Change Spindle Rod for details.
4.5 Left/Right Direction of Boom Pole
The boom pole direction depends on the driving direction of the vehicle. When you look from the
driving direction as shown below, the left boom pole is the one that the boom pole is on the left of
the barrier gate host, and the right boom pole is the one that the boom pole is on the right of the
barrier gate host.
To Next Page
Loading...