Barrier Gate User Manual
68
4.6 Change Left/Right Direction of Machine Core
Before you start
Cut off the power supply. Disassemble the boom pole and spindle rod according to the procedure
above.
Steps
1. Use a cross screwdriver to remove the grounding terminal of the motor wire, and then unplug
the motor power cord and signal line terminals on the barrier gate control board. Rotate the
control box, and remove the motor wire from the wire slot.
Figure 4-16 Remove Machine Core Wire
2. Remove the M8 hex socket head cap screw of the machine core with a No. 6 hex wrench.
3. Rotate the machine core 180° horizontally, and then put it into the host.
Note
The installation position is different after direction is changed.
To Next Page
Loading...