Barrier Gate User Manual
14
2.3.2 Install Boom Pole with Strip Light
Steps
1. Unscrew the cap nuts, spring washers, and flat washers on the other sides of the four
assembling bolts. Save the components and parts for the following installations.
Figure 2-8 Unscrew Assembling Bolts
4. Install the chuck and two cushion blocks to the boom pole with the bolts as shown in the figure
below.
Figure 2-9 Install Chuck and Cushion Blocks
5. Install the boom pole to the spindle rod and fasten the other ends of the bolts with the
disassembled spring washers, flat washers, and cap nuts.
To Next Page
Loading...