Barrier Gate User Manual
16
waterproof cover, waterproof joint, and fixing nut.
4) Pull the strip light cable in the internal host until the white rolling strip limit block on the
strip light cable nears to the waterproof cover.
5) Power off the device. Rotate the boom pole to check if the strip light cable length is
appropriate. Fasten the waterproof cover to the joint after the length is appropriate.
Figure 2-12 Wire Strip Light Cable
2.3.3 Install Anti-collision Cylinder Boom Pole
Steps
1. Stuff the boom pole in the spindle rod aslant as shown in the figure below. Align the
installation hole on the boom pole with that on the spindle rod.
To Next Page
Loading...