Barrier Gate User Manual
19
Figure 2-17 Fix Screws
3) Remove the end cover of the sub-boom pole. Insert the anti-fall adhesive tape into the
sub-boom pole. After the anti-fall adhesive tape is inserted to the limit position, cut the
projecting adhesive tape.
Figure 2-18 Insert Anti-Fall Adhesive Tape
4) Install the end cover to the sub-boom pole.
Figure 2-19 Install End Cover
2. Install the octagonal telescopic boom pole to the host.
1) Unscrew the cap nuts, spring washers, and flat washers on the other sides of the four
assembling bolts. Save the components and parts for the following installations.
Figure 2-20 Unscrew Assembling Bolts
To Next Page
Loading...