HIKVISION DS-TMG520-M/A/B - Page 44

Barrier Gate User Manual
38
Barrier Gate
Control Box
Loop
Vehicle Detector
RELAY1_1
RELAY1_2
LOOP1_A
LOOP1_B
Rise Stop
Fall Learn
AC34V
Nixie
Tube
Motor
Connection
Resistance
Connection
Encoder
Network
Interface
Green Light
Red Light
COM
Rising Control
+
Rising Control
-
Falling Control
+
Falling Control
-
Stopping Control
+
Stopping Control
-
+5V/GND
Rise via Hand Shank
Fall via Hand Shank
Stop via Hand Shank
GND
RS-485-B2
RS-485-A2
5V
GND
RS-485-B
RS-485-A
Induction Input
+
Induction Input
-
Protection Input
+
Protection Input
-
GND
+12V
Bollard Control
2+
Bollard Control
2 -
Bollard Control
1 -
Falling Limit Output
1+
Falling Limit Output
1 -
Rising Limit Output
1+
Rising Limit Output
1 -
Alarm Input
1 +
Alarm Input
1 -
Alarm Input
2 +
Alarm Input
2 -
12V_IN
LED_ARR1 LED_ARR2
GND
12V_OUT
Bollard Control
1 +
Figure 2-46 Connect to Vehicle Detector
Vehicle Detector Installation Instructions
The general width of the vehicle detector is 1 m. If there are large-sized vehicles passing in the
scenario, widen the width to 1.5 m.
The anti-fall vehicle detector should be installed behind the barrier gate to avoid that the boom
pole falls down and smashes the vehicle after the vehicle passes the vehicle detector and the
signal disappears.