HIKVISION DS-TMG520-M/A/B - Set Remote Controller Learning

Barrier Gate User Manual
49
Rising Limit
Position
Press the Rise/Fall button
on the control board to
increase/decrease the value
on the nixie tube.
H3
L3
Hold the Learn button on the control board to enter the menu settings.
H3
Press the Learn button on the control board to save the settings.
H0
Hold the Learn button on the control board.
Press the Rise/Fall button on the control
board to adjust the value on the nixie
tube.
The falling speed: L3 > L2 > L1
Press the Rise button on the remote
controller, press the Rise button on the
control board, or power on the device to
adjust the boom pole to the rising limit
position.
Figure 3-6 Adjust Falling Speed of Boom Pole
Set Remote Controller Learning
Steps
1. Press the Rise button on the remote controller, press the Rise button on the control board, or
power on the device to adjust the boom pole to the rising limit position.
2. Hold the Learn button on the control board until “H0” appears on the nixie tube.
3. Press the Rise/Fall button on the control board to increase/decrease the value on the nixie
tube. Adjust the value to “H4”.
4. Hold the Learn button on the control board until “PA” appears on the nixie tube.
5. Press any button on the remote controller twice, and “00” will appear on the nixie tube.
Learning completed.
6. (Optional) If you want to unpair the remote controller, hold the Stop button on the control
board until “H4” appears on the nixie tube.
7. Press the Learn button on the control board to save the settings. “H4” will appear on the nixie
tube.