HIKVISION DS-TMG520-M/A/B - Set Vehicle Queue Mode

Barrier Gate User Manual
50
Rising Limit
Position
Press the Rise/Fall button
on the control board to
increase/decrease the value
on the nixie tube.
H4
PA
Hold the Learn button on the control board.
00
Press any button on the remote controller twice.
H0
Hold the Learn button on the control board.
Press the Rise button on the remote
controller, press the Rise button on the
control board, or power on the device to
adjust the boom pole to the rising limit
position.
Hold the Stop button on the control board
to unpair the remote controller. H4
Learning completed.
Unparing completed.
Press the Learn button on the control board to save the settings.
H4
Figure 3-7 Set Remote Controller Learning
Set Vehicle Queue Mode
Steps
1. Press the Rise button on the remote controller, press the Rise button on the control board, or
power on the device to adjust the boom pole to the rising limit position.
2. Hold the Learn button on the control board until “H0” appears on the nixie tube.
3. Press the Rise/Fall button on the control board to increase/decrease the value on the nixie
tube. Adjust the value to “H5”.
4. Hold the Learn button on the control board to enter the menu settings.
5. Press the Rise/Fall button on the control board to adjust the value on the nixie tube.
Note
Adjust the value to 1 to enable the vehicle queue mode, and 0 to disable the mode.
6. Press the Learn button on the control board to save the settings. “H5” will appear on the nixie
tube.