Barrier Gate User Manual
60
4.3.2 Change Spindle Rod
Before you start
Adjust the boom pole to the rising limit position, and then cut off the power supply.
Steps
1. Unscrew the cap nuts, spring washers, and flat washers on the other sides of the four
6 m large octagonal
boom pole
Spring with white hook × 1
Spring with red hook × 1
Large octagonal boom pole
spindle rod
1.5 m + 1.5 m folding
boom pole
Spring with white hook × 1
Small octagonal boom pole
spindle rod
2 m + 2 m folding boom
pole
Spring with green hook × 1
Spring with white hook × 1
Small octagonal boom pole
spindle rod
2.5 m + 2.5 m folding
boom pole
Spring with white hook × 2
Small octagonal boom pole
spindle rod
Spring with white hook × 2
Large octagonal boom pole
spindle rod
Spring with white hook × 1
Spring with red hook × 1
Large octagonal boom pole
spindle rod
Large octagonal boom pole
spindle rod
2 m anti-collision cylinder
boom pole
Spring with green hook × 1
Anti-collision round boom pole
spindle rod
3 m anti-collision
cylinder boom pole
Spring with white hook × 1
Anti-collision round boom pole
spindle rod
4 m anti-collision
cylinder boom pole
Spring with green hook × 1
Spring with white hook × 1
Anti-collision round boom pole
spindle rod
6 m boom pole with
strip light
Spring with red hook × 1
Spring with white hook × 1
Spindle rod for boom pole with
strip light
4 m boom pole with
strip light
Spring with green hook × 1
Spring with white hook × 1
Spindle rod for boom pole with
strip light
3 m boom pole with
strip light
Spring with green hook × 1
Spindle rod for boom pole with
strip light
To Next Page
Loading...