Barrier Gate User Manual
62
Figure 4-5 Disassemble Control Box
6. Disassemble the spindle rod and change a new one. Install the M12 fixing bolt of the spindle
rod, and fasten it with a torque no smaller than 60 NM.
Figure 4-6 Change Spindle Rod
7. Fix the M8 × 20 hex socket head cap screw and M8 nut on the side of the spindle rod, rotate
the control box to the original position, and tighten the captive screw with the screwdriver.
Figure 4-7 Reinstall Control Box
8. Repeat the boom pole installation procedure to install a new boom pole.
4.3.3 Change Spring
Before you start
Adjust the boom pole to the rising limit position, and then cut off the power supply.
To Next Page
Loading...