HIKVISION DS-TMG520-M/A/B - Faq

Barrier Gate User Manual
70
A. FAQ
When the barrier gate is abnormal, open the top cover, and observe the fault code on the nixie
tube to troubleshoot.
No.
Code
Description
1
01
● The barrier gate was hit.
● The boom pole does not match.
● The control box was damaged.
2
02
3
03
● The boom pole was blocked from falling by obstacles.
Remove them.
● The spring is too tightened.
● The boom pole does not match.
● Learning limit positions failed. Learn again.
4
04
● There are obstacles on the boom pole or the connection
components. Remove them.
● The spring has reached the inner wall of the host in
compression status. Adjust the spring.
● The boom pole does not match.
● The gearbox was damaged.
● The control box was damaged.
5
05
● The cables of encoder or motor were not connected well.
● The boom pole or the connection component got stuck.
● The motor was damaged.
● The gearbox was damaged.
● The control box was damaged
6
06
● The power input is abnormal.
● The power output of the transformer is abnormal.
● The braking resistor was not inserted.
● The control box was damaged.
7
07
● The power input is abnormal.
● The power output of transformer is abnormal.
● The control box was damaged.
8
0d
● The gearbox was damaged.
● The encoder was interfered.
● The boom pole was damaged.
9
0E
The radar, vehicle detector, or protection signal was triggered
during learning.
10
10
The stopping control or stopping via hand shank terminal was
short-circuited.
11
11
The stopping control or falling via hand shank terminal was