HIKVISION DS-TMG520-M/A/B - Page 77

Barrier Gate User Manual
71
No.
Code
Description
short-circuited.
12
15
FOC timeout.
13
16
The software is abnormal.
14
17
● The braking resistor was damaged or not inserted firmly.
● The control box was damaged.
15
18
The signal cable was not connected well.
16
64
If the device fail to rise to the limit position, but the motor is
running well, the system will reboot if it receives the rise
command.
17
65
If the device fail to fall to the limit position, but the motor is
running well, the system will reboot if it receives the rise
command.
18
66
Learning failed. The system will reboot if it receives the rise
command.
19
68
The motor wiring was not connected well.
20
69
FLASH is abnormal.
21
Lc
The barrier gate is locked. Check if the rising control + and
rising control - interfaces are connected or if the barrier gate is
locked via remote controller.
22
Lr
The barrier gate is in learning limit process, finish it first.