DS-TP50-12DT Terminal Server User Manual
19
4.2 Internal Network Settings
Purpose:
You can configure the IP address for the network interfaces. The default IP address is 192.0.0.64.
Step 1 Go to Configuration > Remote Configuration > Network Settings > Internal Network
Settings.
Figure 4-2 Basic Network Settings
Step 2 Set the NIC Settings.
1) Select the NIC Type in the dropdown list.
2) Enter IPv4 Address, IPv4 Subnet Mask, IPv4 Default Gateway. Or you can select
DHCP (Dynamic Host Configuration Protocol) to obtain IPv4 address dynamically.
Step 3 Set the DNS Server.
Enter the Preferred DNS Server and Alternate DNS Server.
Step 4 Click Save to save the above settings.
4.3 DDNS Settings
Purpose:
If your device access internet via a dynamic IP address, you may set Dynamic DNS (DDNS) to be
used for network access.
Before you start:
Prior registration with your DDNS Provider is required before configuring the system to use DDNS.
Step 1 Go to Configuration > Remote Configuration > Network Settings > DDNS Settings.
To Next Page
Loading...
