HIKVISION DS-TP50-12DT - Page 36

DS-TP50-12DT Terminal Server User Manual
35
Figure 7-3 Monitoring Spot Information
Step 2 Select camera to configure in Select Camera dropdown list.
Step 3 Select Camera Type as Video Surveillance Camera or Intelligent Traffic Camera. The default
Camera Type is Video Surveillance Camera.
 Video Surveillance Camera: Terminal server stores camera video files. Camera picture files
won’t be stored.
 Intelligent Traffic Camera: Terminal server stores both camera video files and picture files.
Step 4 Enter Camera No. and Monitoring Spot No. (Internal).
 Camera No.: Used to distinguish traffic cameras from each other. Enter an exclusive No. for
each camera. It only supports letter and number in 30 bytes.
 Monitor Spot No. (internal): Used to distinguish traffic cameras in different checkpoints. Enter
an exclusive No. for each camera. It only supports number no bigger than 4,294,967,295.
Step 5 Select Direction according to actual installation.
Step 6 Enter detailed information for monitoring spots in the four text contents, including
Monitoring Spot Information 1, Monitoring Spot Information 2, Monitoring Spot Information
3, and Monitoring Spot Information 4:.

Valid Monitoring Spot Information 1: No more than 120 characters.

Valid Monitoring Spot Information 2: No more than 40 characters.

Valid Monitoring Spot Information 3: No more than 30 characters.

Valid Monitoring Spot Information 4: No more than 24 characters.
Step 7 Click Save to save the settings.