High Performance Event Detection Server • User Manual
9
Chapter 3 Configure Network
Purpose:
Guarantee the network connection between your computer and the device is correct, thus you can
control the device remotely.
Configure Port
The terminal device which is listened, should be set as listened mode.
Go to System > Sys Config > Basic Configuration.
Port Configuration
Edit the Server IP Address, Server Port, and SDK Port.
Click Save to save the settings.
Reboot the device to activate the new settings.
Configure Network
Go to Network, you can view smart analysis unit information and status.
Check UID Indicator, to rapidly locate the server.
Go to Network > Local > Configuration > Basic Configuration, to edit the basic network
settings.
Go to Network > Local > Configuration > Network Configuration > LAN.
To Next Page
Loading...
