HIKVISION IPC-4300H - Page 122

UM IPC-4300H 040320NA 122
Table 3, Digital Multimeter Features
AC/DC
Voltage and current measurement state
display
Auto-Range
The multimeter automatically adjusts the
range according to input signal or tested
components.
Data Hold
Hold data
Relative Measurement
Display the relative measurement value.
Press the key to change display state.
10 A Socket
For 10 A current measurement situations,
use a 10 A socket.
Over Range
The current measurement value is above
the range. Switch to Auto if in the Auto
Range state.
• Operating Instructions
DC Voltage Measurement
• Connect the black test lead to the COM port and the red test lead
to the V/Ω port.
• Select U and enter the DC Voltage Measurement setting.
• The Tester is in Auto Range status by default. Click DC Auto Range
and press the key to manually select range, or to restore Auto
Range.
• Manual Ranges: 0.000 V  6.600 V, 00.00 V  66.00 V, 000.0 V 
660.0, 000.0 mV  660.0 mV
AC Voltage Measurement
• Connect the black test lead to the COM port and the red test lead
to the V/Ω port.
• Select Ũ to enter the AC Voltage Measurement section.