UM IPC-4300H 040320NA 125
• Auto Range is the Tester’s default status. Press the key to
manually select a range. Press Near to restore Auto Range.
• Manual Ranges: 000.0 Ω 660 Ω, 0.000 kΩ 6.600 kΩ, 00.00 kΩ
66.00 kΩ, 000.0 kΩ 660.0 kΩ, 0.000 MΩ 6.600 MΩ, 00.00 MΩ
66.00 MΩ
Figure 123, Resistance Measurement Lead Setup
Continuity Testing
• Connect the black test lead to the COM port and the red test lead
to the V/Ω port.
• To select , enter the Continuity Test section. Connect the test
leads across two points of the circuit being tested.
• If continuity exists (i.e., resistance is less than about 50 Ω), the
built-in buzzer will sound.
Figure 124, Continuity Testing Lead Setup
To Next Page
Loading...