Network Video Recorder User Manual
117
Step 4 Check Enable Face Detection.
Step 5 Optionally, check Save VCA Picture to save the captured pictures of face detection.
Step 6 Drag the Sensitivity slider to set the detection sensitivity. Sensitivity range: [1-5]. The higher
the value is, the more easily the face can be detected.
Step 7 Set the arming schedule. Refer to Chapter 11.1 Configure Arming Schedule.
Step 8 Set the linkage actions. Refer to Chapter 11.2 Configure Alarm Linkage Actions.
Step 9 Click Apply.
12.2 Vehicle Detection
Purpose:
Vehicle Detection is available for the road traffic monitoring. In Vehicle Detection, the passed
vehicle can be detected and the picture of its license plate can be captured.
Step 1 Go to System > Event > Smart Event.
Step 2 Click Vehicle.
Figure 12-2 Vehicle Detection
Step 3 Select a Camera to configure.
Step 4 Check Enable Vehicle Detection.
Step 5 Optionally, check Save VCA Picture to save the captured pictures of vehicle detection.
To Next Page
Loading...
