Network Video Recorder User Manual
145
Chapter 16 System Maintenance
16.1 Storage Device Maintenance
16.1.1 Configure Disk Clone
Purpose:
Select the HDDs to clone to eSATA HDD.
Before you start:
Connect an eSATA disk to the device.
Step 1 Go to Maintenance > HDD Operation > HDD Clone.
Figure 16-1 HDD Clone
Step 2 Check the HDD to clone. The capacity of selected HDD must match the capacity of clone
destination.
Step 3 Click Clone.
Step 4 Click Yes on popup message box to continue clone.
To Next Page
Loading...
