HIKVISION iVMS-Blazer Pro/256/16H - IR Remote Control Operations

Network Video Recorder User Manual
18
Table 1-1 Description
No.
Name
Description
1
Panel lock
Locks or unlocks the panel by the key.
2
Power switch
 Powers on/off device.
 Solid blue: device is running. Solid red: device is
shut down.
3
Muting switch
Turn on/off buzzer.

Solid blue: buzzer is turned off.

Unlit: buzzer is turned on.
4
HDD status indicator
 Solid red: at least one HDD is installed.
 Unlit: no HDD is detected.
 Blinking red: HDD is reading/writing.
5
Tx/Rx status indicator
Blinking blue: network communication is normal.
6
USB interfaces
2 USB 2.0 interfaces to connect additional devices such
as USB mouse and USB keyboard for server board.
Connect USB devices like USB drive to USB interface in
rear panel.
7
HDD sequence indicator
Shows the HDD installation slot.
1.2 IR Remote Control Operations
The device may also be controlled with the included IR remote control, shown in Figure 1-3.
Batteries (2×AAA) must be installed before operation.
The IR remote is set at the factory to control the device (using default Device ID# 255) without any
additional steps. Device ID# 255 is the default universal device identification number shared by the
devices. You may also pair an IR Remote to a specific device by changing the Device ID#, as follows: